Quick Start
===========

Get MouseMaster working in 5 minutes.

Step 1: Open the Module
-----------------------

Navigate to **Modules > Utilities > MouseMaster**.

Step 2: Select Your Mouse
-------------------------

In the **Mouse Selection** section:

1. Choose your mouse model from the dropdown
2. If your mouse isn't listed, select "Generic 5-Button" or click "Detect New Mouse..."

Step 3: Choose a Preset
-----------------------

.. image:: ../../Screenshots/preset-selector.png
   :alt: Preset selector interface
   :width: 100%

In the **Preset Management** section:

1. Select a built-in preset for your workflow, or
2. Click "New Preset" to create your own

Available built-in presets:

- **Default**: Basic undo/redo on back/forward buttons
- **Segmentation Workflow**: Optimized for Segment Editor
- **Markups Workflow**: Quick fiducial placement

Step 4: Enable MouseMaster
--------------------------

Click the **Enable Mouse Master** button at the top of the panel.

The status indicator should turn green, showing MouseMaster is active.

Step 5: Test Your Configuration
-------------------------------

1. Create a simple action in Slicer (e.g., add a markup point)
2. Press your mapped buttons (e.g., Back for Undo)
3. Verify the expected actions occur

That's it! You're ready to use MouseMaster.

Next Steps
----------

- :doc:`button-mapping` - Customize button assignments
- :doc:`presets` - Save and share your configurations
- :doc:`context-bindings` - Set up module-specific bindings